Numerical Characterization on Fracture Evolution Behavior of Pre-Flawed Sandstone under Monotonic and Multilevel Cyclic Loading

This study employed an improved stress corrosion model within a three-dimensional particle flow program to investigate the mechanical and cracking behavior of fractured sandstone samples with varying rock bridge angles under both monotonic loading and multilevel cyclic loading. Firstly, using the experimental results from intact sandstone under uniaxial compression, we calibrated the microscopic mechanical parameters of the parallel bond model. Then, the model was validated using the experimental results of fractured sandstone under monotonic and cyclic loading. Finally, the initiation, propagation, and coalescence behavior of cracks in fractured sandstone samples under the above two loading paths, as well as the evolution process of the stress field, displacement field, and force chain distribution, were discussed in detail. The results show that the stress–strain curves, strength, deformation parameters, and macroscopic failure modes obtained from numerical simulations are consistent with those from laboratory mechanical tests. The mechanical behavior of fractured sandstone is influenced by both the rock bridge angle and the loading path. As the rock bridge angle decreases, the mechanical parameters of the sample show an increasing trend, and the influence of rock bridge angle on the failure mode is reduced. Cracks in the samples all initiate at the tips of pre-existing flaws, and the rock bridge angle affects the crack propagation and coalescence process: for sandstones with smaller rock bridge angles, cracks gradually extend to the sample’s ends; for sandstones with larger rock bridge angles, direct coalescence of cracks at the rock bridge is observed, then extending to the sample’s ends. Compared with monotonic loading, the damage degree of sandstone samples under multilevel cyclic loading is more severe, and even obvious block spalling is observed. The experimental and numerical simulation results are expected to improve the understanding of the mechanical behavior and fracture behavior of fractured rocks under monotonic and multilevel cyclic loading.