Flexible UV Photodetector Based on Graphite/titanium Dioxide Through Facile Transfer of Pencil Drawn Graphite Films on Desired Substrates

Assembly of graphite structures through pencil drawn method is considered among the most facile and inexpensive approaches for a wide range of electronic and optoelectronic applications. However, the typical limitation of this methodology is that the films and structures can be drawn on a very limited number of substrates. Here, we report a novel methodology for the transfer of pencil drawn graphite films on desired substrate. The graphite films are transferred from cellulose paper, textile and wood paper onto flexible and transparent acrylic tape. The novel wood paper substrate is also used for the fabrication of bar device using a mask which is then transferred onto the acrylic tape. TiO2 nanoparticles paste is coated on the surface of transferred bar device. Scanning electron microscopy, energy dispersive X-ray spectroscopy, X-ray diffraction analysis, and UV–visible spectroscopy of graphite and graphite/TiO2-NPs electrodes are performed respectively to study their morphological, compositional, structural and optical features. The fabricated device acts as a UV photodetector and delivers a photocurrent as higher as 197.68 μA, photoresponsivity of 8.94 mA W−1, detectivity of 4.16 × 109 Jones at bias voltage of 5 V, response time of ∼860 ms and recovery time of ∼890 ms. The flexibility of the demonstrated photodetector is evaluated through recording changes in photocurrent under bending positions from 0 to 150°, and after employing bending cycles up to 1000. The results show that the fabrication of photodetector is facile and low-cost, and it offers valuable working compatibility under bending strains. Moreover, the flexibility of photodetectors enables their effective integration with human skin and clothes for human health monitoring applications.