Influence of operating parameters on metal flow and thermal characteristics in an EMBr-single-ruler controlled CSP funnel-shaped mould

Electro-magnetic brake (EMBr), as a necessary technique to adjust the metal flow within the mould, has been extensively applied in the continuous casting (CC) production. The EMBr technique, if appropriately applied, can take the benefit of braking effect to weaken jet impingement effect, suppress fluid disturbance and stabilize surface fluctuation. As a result, to obtain a reasonable flow pattern within the CC mould, the braking performance of EMBr technique needs to be flexibly adjusted according to the variation of operational parameters. In this article, to obtain a braking performance of a commonly used EMBr-single-ruler technique within an optimal range, the effect of operating parameters on the metal liquid flow and thermal characteristics in a compact strip production (CSP) thin slab mould is described through a 3-D mathematical modeling of multi-physical field coupling. The results illustrate that the braking performance of the EMBr-single-ruler device is weakened with the increase of the casting speed or the mould width. For the effect of the casting speed and mould width on the metal flow with the application of an EMBr device, an optimum braking performance of the EMBr-single-ruler device can be obtained under the matching parameters of a magnetic induction intensity of 0.30 T and a casting speed of 4.5 m ∙ min‒1 together with a mould width of 1500 mm. Relative to the absence of the EMBr-single-ruler device, the maximum surface fluctuation height is controlled at 6.2 mm, and the mean surface temperature is raised to 1803.6 K. Based on these findings, we conclude that the proper utilization of the EMBr-single-ruler device can avoid the entrainment of flux powder and improve the melting performance of flux powder.