Investigation of the Degree of Monomer Conversion in Dental Composites Through Various Methods: an in Vitro Study

The degree of monomer conversion (DC) values of three different dental composites were examined using three different methods: surface microhardness (ratio of bottom/top), Fourier-transform infrared (FT-IR), and differential scanning calorimetry (DSC). Two of the dental composites included in the study were nanohybrid (Dentsply Neo Spectra ST HV and Omnichroma), and one was a microhybrid-labeled newly marketed composite containing nanoparticles (Dentac Myra). Composite discs were prepared according to the methodology for all methods and analyzed (2 mm thickness × 5 mm diameter). Surface microhardness values were measured in Vickers Hardness Number (VHN), while FT-IR and DSC values were obtained in percentage (%). Significant differences were observed in both bottom/top surface microhardness values and DC values obtained from FT-IR. However, there was no statistical difference in the ratio of bottom/top microhardness values. Neo Spectra ST HV exhibited superior performance in both microhardness and monomer conversion compared to the other two composites. Newly marketed Myra showed values close to Omnichroma. It was found that the values obtained by the DSC method were parallel to those obtained by FT-IR. In conclusion, the structure of dental composites leads to different mechanical properties. Additionally, DSC measurements and FTIR spectra were found to be complementary techniques for characterizing monomer conversion values.