Joint Inversion Method of Nuclear Magnetic Resonance Logging Multiwait Time and Multiecho Time Activation Data and Fluid Identification

Summary Nuclear magnetic resonance (NMR) logging is effective for reservoir evaluation; at present, NMR logging data acquisition parameters are primarily divided into dual wait time (TW) and dual echo time (TE) and then are analyzed, respectively. However, the interpretation results of the two activations are often inconsistent and confuse the identification and quantitative evaluation of reservoir fluids. Based on the principle of multi-TW and -TE activations of NMR logging, the relaxation mechanism is analyzed, and the relationship between the amplitude of the echo train and the pore structure, fluid types, and content of different activations is established. The joint system of the amplitude of echo trains in multiactivations is constructed. Then, the difference spectrum and the oil porosity of the flushed zone can be calculated by the least squares algorithm (LSQR). The fluid-saturated rock model is set, and the numerical simulation of NMR is used to verify the data joint inversion is correct and that the calculation result is more accurate than the previous time domain analysis (TDA) processing method. Moreover, the oil porosity of the flushed zone-deep induction resistivity crossplot is constructed and is also proposed to identify fluid. The above method was applied to the Yanchang Formation in the western Ordos Basin. Based on the joint inversion of NMR multi-TW and -TE logging data in the study area, the methodology yields more precise calculations of fluid volume and saturation compared with conventional approaches. The crossplots derived from these calculations demonstrate high efficacy in identifying fluid types; therefore, the method for fluid identification exhibits potential for practical application and holds considerable value for widespread adoption in the field.