Enhancing Load-Bearing Capacity of Martensitic Stainless Steel Resistance Spot Welds: Microstructural vs. Geometrical Approaches

The load-bearing capacity of resistance spot welds is determined by a combination of weld geometrical attributes, such as the size of the weld nugget (WN), and weld metallurgical features. When resistance spot welds are made on martensitic stainless steels (MSSs), their load-bearing capacity is reduced due to the formation of a brittle martensitic microstructure within the WN. In this study, we investigated two distinct approaches to enhance the mechanical properties of AISI420 MSS spot welds. The results indicated that manipulating the WN size did not effectively produce strong welds in both tensile-shear (TS) and cross-tension (CT) tests. Therefore, we focused on examining the impact of the weld microstructure by employing two different interlayers: low carbon steel (LCS) and pure nickel. The analysis using electron backscatter diffraction (EBSD) and electron probe microanalysis (EPMA), along with equilibrium and non-equilibrium phase diagrams, revealed that the microstructure of the WN with low carbon steel interlayer of various thicknesses exhibited similarities with spot welds made without an interlayer, and the solidification mode was still δ-ferrite. This microstructure primarily consisted of martensite (M) and likely residual delta ferrite (δ) phases, resulting in no significant improvements in mechanical properties. In contrast, the utilization of the nickel interlayer led to remarkable enhancements in mechanical properties. This improvement can be attributed to a shift in the solidification mode from primary delta (δ) to austenite (γ) within an optimal interlayer thickness. This transition facilitated the development of a predominantly austenitic (γ) microstructure, contributing to the formation of an exceptionally tough microstructure within the weld nugget. Consequently, the load-bearing capacity was significantly improved.