Numerical simulation of the simultaneous propagation of multiple hydraulic fractures based on expanded finite element method

Hydraulic fracturing technology with horizontal wells is a highly efficient approach to stimulate the unconventional reservoir by creating lots of fractures to increase the oil and gas recovery rate. However, some field monitoring data indicate that multiple fractures could not propagate uniformly due to stress interference, which leads to a lower stimulation volume and production capacity. Therefore, investigating the stress interference mechanism between multiple fractures is important to obtain a higher production capacity for unconventional reservoirs. In this study, a two-dimensional XFEM (expanded finite element method) model was established to investigate the influence of stress interference on the fracture propagation of multiple fractures in horizontal wells. The different injection parameters, completion parameters, and fracturing patterns were investigated by sixteen simulation cases. The results show that first the influencing degree of stress interference from different parameters is fracture spacing, injection flow rate, number of fractures, and fluid viscosity, respectively. Second, compared to the simultaneous fracturing and sequential fracturing, the zip fracturing pattern (sides fractures created first and then mid-fracture) could create more uniform fractures in the reservoir. Third, a small fracture spacing and a higher injection flow rate could lead to a faster stress interference, but the fluid viscosity and the number of fractures have little effect on the occur timing of stress interference. This study could provide some meaningful perspective on the field fracturing design in horizontal wells.