Blood bupivacaine concentrations after pecto-serratus and serratus anterior plane injections of plain and liposomal bupivacaine in robotically-assisted mitral valve surgery: Sub-study of a randomized trial

Study objective To investigate the timing of peak blood concentrations and potential toxicity when using a combination of plain and liposomal bupivacaine for thoracic fascial plane blocks. Design Pharmacokinetic analysis. Setting Operating room. Patients Eighteen adult patients undergoing robotically-assisted mitral valve surgery. Interventions Ultrasound-guided pecto-serratus and serratus anterior plane blocks using a mixture of 0.5% bupivacaine HCl up to 2.5 mg/kg and liposomal bupivacaine up to 266 mg. Measurements Arterial plasma bupivacaine concentration. Main results Samples from 13 participants were analyzed. There was substantial inter-patient variability in plasma concentrations. A geometric mean maximum bupivacaine concentration was 1492 ng/ml (range 660 to 4650 ng/ml) at median time of 30 min after injection. In 4/13 (31%) patients, plasma bupivacaine concentrations exceeded our predefined 2000 ng/ml toxic threshold. A second much smaller peak was observed about 32 h after the injection. No obvious signs of local anesthetic toxicity were observed. Conclusions Combined injection of plain and liposomal bupivacaine for pecto-serratus/serratus anterior plane blocks produced a biphasic pattern, with the highest arterial plasma concentrations observed within 30 min. Maximum concentrations exceeded the potential toxic threshold in nearly a third of patients, but without clinical evidence of toxicity. Clinicians should not assume that routine combinations of plain and liposomal bupivacaine for thoracic fascial plane blocks are inherently safe.