Fracture response of thermal-treated granite under mode III loading: Through the edge-notched diametrically compressed disk specimen

The deep rock mass is subject to a high degree of coupling of geothermal and complex loading, and complex mechanical and hydraulic loading induces out-of-plane progression of primary fractures, culminating in the formation of pure mode III fractures. To study the impact of high temperatures on the fracture behavior of pure mode III, the edge-notched diametrically compressed (ENDC) granite discs were heat treated at different temperatures (25, 200, 400, 500, and 600 °C). Subsequently, comparative tests were conducted on both pure mode III and pure mode I fracture, using the digital image correlation (DIC) method and the acoustic emission (AE) technique. The results demonstrate that as the temperature increases, the mass and P-wave velocity decrease. Furthermore, under pure mode III loading, the ENDC sample exhibits higher peak loads and fracture toughness (KIIIc) compared to mode I (KIc), which shows a decrease of 60.72 % in KIIIc and 73.75 % in KIc after thermal treatment at 600 °C compared to the ambient conditions. Simultaneously, the elevated temperature augmentes the cumulative AE counts during loading. The variations in horizontal displacement elevation deviation (HDED) on either side of the deformation concentration zone indicate that the samples are more resistant to crack extension under pure mode III loading. In addition, a positive linear correlation is noted between KIIIc and KIc of ENDC disc samples. The relationship between rebound values and fracture toughness of ENDC discs was discussed, and discovered that the KIIIc and KIc values are quadratic with the rebound values tested by the complete disc. The discussed results may serve as an initial prediction of fracture toughness values.