Assessing the Utilization of Sawdust in Water-Based Drilling Fluid for Managing Fluid Loss and Enhancing Viscosity

The evaluation of the use of sawdust in drilling fluid formulation is covered in this study. The investigation focused on the physicochemical and rheological properties of water-based mud (WBM) drilling fluids that included four different dosages of sawdust. These properties included yield stress, plastic viscosity, rheological behavior, gel strength, filtration test (API filtrate; American Petroleum Institute), and pH. The sawdust was employed as a substitute for the polymers commonly used in water-based muds (WBMs) to serve either as a viscosifier or as a fluid loss controller. The current study set out to evaluate how sawdust (diameter <= 630 mu m) affected the primary characteristics of the drilling muds. Sawdust was utilized in place of carboxymethyl cellulose polymer (CMC) as a viscosifier and polyanionic cellulose polymer (PAC) as a filtrate reducer at several dosages (0, 10, 20, 50, and 100 g/L). It was found that the sawdust dosage and its role had a significant impact on the rheological characteristics of the drilling fluids. At amounts between 20 and 50 g/L, the sawdust was added as a viscosifier to the drilling fluids under study, resulting in a significant improvement in their physicochemical and rheological parameters (yield stress, plastic viscosity, and gel strength). However, the drilling fluids showed extremely high rheological properties and a viscosity that can slow down fluid circulation in the well when 100 g/L of sawdust were used, totally substituting for the polymers.