A novel photo-enzyme platform based on non-metallic modified carbon nitride for removal of bisphenol A in water

A nonmetallic composite photocatalyst with 2D/2D structure was prepared by hydrothermal in -situ polymerization and used for the immobilization of cytochrome C (Cyt c). The photo-enzyme coupling system has a very high enzyme load, which can reach 528.29 mg g 1 after optimization. Compared with free Cyt c, Cytc/PEDOT/ CN showed better enzymatic activity, stability and catalytic efficiency. Even after being stored at 100 degrees C for 60 min, the enzyme activity remained at 49.42 % and remained at 57.89 % after 8 cycles. Moreover, Cytc0.5/ PEDOT3/CN showed excellent photocatalytic degradation performance in the degradation experiment of bisphenol A (BPA), reaching 68.22 % degradation rate within 60 min, which was 3.9 times higher than that of pure g-C3N4 and 1.61 times higher than that of pure PEDOT3/CN. This study shows that the introduction of conductive polymers is of great significance to the photo-enzyme coupling system and provides a new strategy for the treatment of phenol-containing wastewater.