Effects of Thermal Exposure on the Microstructure and Mechanical Properties of a Ti-48Al-3Nb-1.5Ta Alloy via Powder Hot Isostatic Pressing

Research on how thermal exposure affects the microstructure and mechanical properties of the Ti-48Al-3Nb-1.5Ta (at. %) alloy, which is prepared via powder hot isostatic pressing (P-HIP), is essential since this low-density alloy shows promise for use in high-temperature applications, particularly for aero-engines, which require long-term stable service. In this study, a P-HIP Ti-48Al-3Nb-1.5Ta (at. %) alloy was exposed to high temperatures for long durations. The phase, microstructure and mechanical properties of the P-HIP Ti-48Al-3Nb-1.5Ta alloy after thermal exposure under different conditions were analyzed using XRD, SEM, EBSD, EPMA, TEM, nanomechanical testing and tensile testing. The surface scale is composed of oxides and nitrides, primarily Al2O3, TiO2, and TiN, among which Al2O3 is preferentially generated and then covered by rapidly growing TiO2 as the thermal exposure duration increases. The nitrides appear later than the oxides and exist between the oxides and the substrate. With increasing exposure temperature and duration, the surface scale becomes more continuous, TiO2 particles grow larger, and the oxide layer thickens or even falls off. The addition of Ta and Nb can improve the oxidation resistance because Ta5+ and Nb5+ replace Ti4+ in the rutile lattice and weaken O diffusion. Compared with the P-HIP Ti-48Al-3Nb-1.5Ta alloy, after thermal exposure, the grain size does not increase significantly, and the gamma phase increases slightly (by less than 3%) with the decomposition of the alpha 2 phase. With increasing thermal exposure duration, the gamma phase exhibits discontinuous coarsening (DC). Compared with the P-HIP Ti-48Al-3Nb-1.5Ta alloy, the hardness increases by about 2 GPa, the tensile strength increases by more than 50 MPa, and the fracture strain decreases by about 0.1% after thermal exposure. When the depth extends from the edge of the thermally exposed specimens, the hardness decreases overall.