High-performance liquid chromatographic enantioseparation of azole analogs of monoterpene lactones and amides focusing on the separation characteristics of polysaccharide-based chiral stationary phases

High-performance liquid chromatography-based enantioseparation of newly prepared azole analogs of monoterpene lactones and amides was studied. Effects of additives and mobile phase composition were evaluated both in normal and polar organic modes. Applying amylose tris-(3,5-dimethylphenylcarbamate) selector in normal and polar organic modes acid and base additives were found to affect the peak profiles, without significantly influencing the enantiorecognition ability of the studied selector. In most cases, differences observed in retention times and enantioselectivities were lower than 10 and 20 % under normal phase and polar organic conditions, respectively. Under normal phase conditions decreased retention was observed for all the studied analytes with increased eluent polarity. Interestingly, enantioselectivity was only slightly (<10 %) influenced by the variation in the n-hexane/2-propanol ratio between 80/20 and 20/80 v/v. In polar organic mode, five different neat solvents (acetonitrile, methanol, ethanol, 1-propanol, and 2-propanol) were tested, and the best results were obtained with acetonitrile and ethanol in the case of Lux Amylose-1 column with enantioresolutions most often above 2. Based on results obtained with amylose and cellulose-based columns the amylose tris-(3,5-dimethylphenylcarbamate) selector is found to offer a superior performance both in normal and polar organic modes. When evaluating the possible effects of the selector immobilization, no striking differences were found in the normal phase. Usually, enantioselectivities and resolutions were higher (10-20 %), while retention factors of the first peaks were lower (20-30 %), on the coated-type column. In contrast, in polar organic mode, the retention characteristics and enantiorecognition ability of the coated and immobilized selectors were heavily affected by the nature of the polar solvent. Special attention has been paid to the history-dependent behavior of polysaccharide-based selectors. A confidence interval-based evaluation is suggested to help comparison of the histereticity observed in different systems. Several examples are shown to confirm that the recently discovered hysteresis is a common characteristic of polysaccharide-based selectors.