Superior mechanical properties of a Zr-based bulk metallic glass via laser powder bed fusion process control

Additive manufacturing has made the fabrication of large-dimensioned bulk metallic glasses (BMGs) achievable; however, questions remain regarding how to control the processing parameters to obtain dense and fully amorphous BMGs with desirable mechanical properties. Here, laser powder bed fusion (LPBF) was used to produce dense and fully amorphous Zr59.3Cu28.8Nb1.5Al10.4 BMG samples from two different starting powders within a large processing window of laser powers and scanning speeds. X-ray diffraction (XRD) revealed that fully amorphous XRD patterns were obtained for samples with high relative densities (>99 %) when the LPBF energy density ranged from similar to 20 J/mm(3) up to similar to 33 J/mm(3) for coarse powder with low oxygen and up to similar to 30 J/mm(3) for fine powder with higher oxygen. For the fully XRD amorphous samples, strength and hardness increased with increasing energy density while the relaxation enthalpy and ductility decreased. Transmission electron microscopy revealed that the softer samples contain larger medium range order clusters within the amorphous matrix. With higher LPBF energy density, high relative density was still achieved along with devitrification and embrittlement. While lower energy densities below similar to 20 J/mm(3) could retain a fully XRD amorphous structure, such samples had relative densities <99 %. When comparing the two powders, the coarse powder with four times lower oxygen content gave better glass forming ability, compression ductility up to 6 % plastic strain, and fracture toughness up to similar to 38 MPa root m. These findings demonstrate that it is possible to tailor the structure and mechanical properties of BMGs by tuning the LPBF process parameters within a wide processing window.