Evaluation of Single Event Upset on a Relay Protection Device

Traditionally, studies have primarily focused on single event effects in aerospace electronics. However, current research has confirmed that atmospheric neutrons can also induce single event effects in China's advanced technology relay protection devices. Spallation neutron irradiation tests on a Loongson 2K1000 system-on-chip based relay protection device have revealed soft errors, including abnormal sampling, refusal of operation and interlock in the relay protection device. Given the absence of standardized evaluation methods for single event effects on relay protection devices, the following research emphasizes the use of Monte Carlo simulation and software fault injection. Various types of single event upsets, such as single bit upsets, dual bit upsets, and even eight bit upsets, were observed in Monte Carlo simulations where atmospheric neutrons hit the chip from different directions (top and bottom). The simulation results indicated that the single event effect sensitivity of the relay protection device was similar whether the neutron hit from the top or the bottom. Through software fault injection, the study also identified soft errors caused by neutron induced single event upsets on the Loongson 2K1000 system, including failure to execute, system halt, time out, and error result. And the soft error number of system halts and error results exceeded that of time outs and failures to execute in all three tested programs. This research represents a preliminary assessment of single event effects on relay protection devices and is expected to provide valuable insights for evaluating the reliability of advanced technology relay protection devices.