Dual-mode colorimetric and photothermal aptasensor for detection of kanamycin using flocculent platinum nanoparticles

Chitosan (CS)-stabilized platinum nanoparticles (CS/PtNPs) were employed to develop a novel aptamer-based dual-mode colorimetric and photothermal biosensor for selective detection of kanamycin (KAN). As a peroxidase-like catalyst, the CS/PtNPs showed outstanding catalytic activity for the oxidation of 3,3 ',5,5 '-tetra- methylbenzidine (TMB) in the presence of hydrogen peroxide (H2O2). As a stabilizing agent, CS excelled at fixing the KAN binding aptamer on the surface of the CS/PtNPs, amplifying their catalytic activity and enhancing colloidal dispersion and stability. The oxidized TMB (TMBox) functioned as a signal for the colorimetric, photothermal aptasensor because of its observable absorbance of light in the visible and near-infrared (NIR) regions. When light from a NIR laser was absorbed by the TMBox in the reaction solution, heat was generated in inverse proportion to the KAN concentration. The developed colorimetric and photothermal modes of the aptasensor showed a linear detection range of 0.1-50 and 0.5-50 mu M, with a limit of detection (LOD) of 0.04 and 0.41 mu M, respectively. Moreover, the aptasensor successfully determined KAN concentrations in spiked milk samples, verifying the reliability and reproducibility in practical applications. The dual-mode aptasensor based on CS/ PtNPs for KAN detection, utilizing both color change and heat generation signals through a single probe (TMBox), demonstrates rapid response, simplicity in operation, cost-effectiveness, and high sensitivity. In addition, unlike typical immunoassays, this aptamer-based peroxidase-like nanozyme activation and inhibition strategy required no washing process, which was very effective in terms of reducing the time required for an assay and sustaining a high sensitivity.