An anionic polyethersulfone membrane modified by poly (2-acrylamide-2-methylpropanesulfonic acid sodium salt) grafted carbon nanotubes

Polyethersulfone membrane is easy to be polluted, and the negative surface would help enhance improve the permeability and the anti-pollution performance; so how to anchor polymer brushes with negative groups to polyethersulfone membrane surface is a challenge. In this paper, polymer brushes of poly(2-acrylamide-2-methylpropanesulfonic acid sodium salt) is first grafted to carbon nanotubes to form an organic-inorganic hybrid additive, which is further anchored onto the membrane surface of polyethersulfone by blending method. The graft reaction is proceeded by surface initiated electrochemical atom transfer radical polymerization, where the introduction of electrochemical part is because it could help better control the growth of polymer brushes compared with the pristine atom transfer radical polymerization process. The carbon nanotubes grafted with poly(2-acrylamide-2-methylpropanesulfonic acid sodium salt) could anchor on the membrane surface because the there is a self-assemble process of organic-inorganic hybrid additive during phase inversion method, where the inorganic part carbon nanotubes firmly embedded into the membrane and the organic part can be fixed on membrane surface. The polyethersulfone membrane exhibits enhanced surface hydrophilicity, improved the permeability of the membrane, and good anti-fouling performance due to the negative charge and electrostatic repulsion brought by anionic surface of the modified membrane. When the mass of nanotubes grafted with poly(2-acrylamide-2-methylpropanesulfonic acid sodium salt) in the casting solution is 20 mg, the water flux can reach 365.5 L m(-2) h(-1), and the rejection ratios of both BSA and CR are close to 100% with good flux recovery and anti-fouling effect performance.