The Effects of Residual Femoral Deformity on Computed Contact Mechanics in Patients Treated With In Situ Fixation for Slipped Capital Femoral Epiphysis

JOURNAL OF PEDIATRIC ORTHOPAEDICS(2024)

引用 0|浏览1
暂无评分
摘要
Objective:In situ fixation for treatment of slipped capital femoral epiphysis (SCFE) can stabilize the epiphysis and prevent further joint deformation but often leaves residual deformity that may adversely affect intra-articular contact mechanics. The purpose of this study was to investigate the relationship between residual deformity and contact mechanics in the post-SCFE hip.Methods:Patient-specific hip models were created for 19 patients with SCFE treated with in situ fixation. For each model, discrete element analysis was used to compute cumulative acetabular and femoral contact stress exposure during a walking gait cycle. Slip severity was evaluated for each patient using the two-dimensional Southwick angle and a novel three-dimensional (3D) assessment of multiplanar femoral deformity (3D slip angle).Results:Of the SCFE cases, 2/7 mild (Southwick angle <= 30 degrees) had peak cumulative femoral exposures equivalent to that of severe (Southwick angle >= 60 degrees) cases. Severe SCFE cases had higher peak (P = 0.015) and mean (P = 0.028) femoral contact stress exposure and lower cumulative femoral contact area (P = 0.003) than mild (Southwick angle <= 30 degrees) SCFE cases. Mean femoral contact stress exposure was also higher in severe SCFE cases than in moderate SCFE cases (P = 0.027). Acetabular and femoral contact mechanics metrics typically demonstrated stronger correlations with 3D slip angle than two-dimensional Southwick angle.Conclusions:Increased slip severity adversely impacts intra-articular femoral contact mechanics. Contact mechanics metrics demonstrate higher correlations with 3D slip angle, indicating that this novel measurement may better describe global deformity and its relationship to intra-articular mechanics; however, the modest strength of these correlations may also imply that global impingement-generating deformity is not the primary factor driving contact mechanics in the post-SCFE hip.Clinical Relevance:Greater slip severity adversely impacts contact mechanics in the post-SCFE hip. However, focal regions of high contact stress were seen even in mild SCFE deformities, suggesting some type of deformity correction should be considered even for mild slips to alleviate secondary impingement, address focal incongruities, and reduce osteoarthritis development/progression.
更多
查看译文
关键词
discrete element analysis,contact stress,slipped capital femoral epiphysis,in situ fixation,femoroacetabular impingement
AI 理解论文
溯源树
样例
生成溯源树,研究论文发展脉络
Chat Paper
正在生成论文摘要