Advance processing of cluster-free CNT reinforced 6082 Al matrix nanocomposites: influence of mechanical milling and cryomilling

In the present study, lightweight high-strength carbon nanotubes (CNTs) reinforced aluminium-based composite was fabricated through powder metallurgical processing. The effect of planetary milling and cryogenic assisted milling on the structure, morphology, mechanical properties, phase composition, and thermal stability of CNTs reinforced Al6082 Al nanocomposites powders was investigated using X-ray diffraction (XRD), scanning electron microscope (SEM)- Energy dispersive spectroscopy (EDS), transmission electron microscope (TEM), and indentation techniques. The CNTs in the Aluminium (AL) matrix were distributed uniformly after 50 h of milling. Further, the cryomilling of 50 h milled Aluminium matrix composites (AMC) decreases agglomeration even more and was successful in cleaving the nanotubes as well as minimising entanglements. The broadening of diffraction peaks suggests a reduction in the crystallite size (from similar to 36 to similar to 20 nm) and an increase in induced strain. Milled powders were consolidated through the hot-press and spark plasma sintering technique. The mechanical properties of these AMCs were evaluated through indentation for hardness (>250 HV) and compressive testing techniques. SPSed samples reported better properties in comparison to hot-pressed samples. It is discovered that post-CM of Mechanical Milling (MM) powder aids in overcoming issues related to the agglomeration of Al/CNT composites, and the goal to fabricate tangle-free CNT reinforced composite was achieved. Moreover, it showed enhanced mechanical properties with a maximum yield strength of 210 MPa and good synergy between strength and ductility.