Experimental Investigation on the Applicability of Microwave-Modified Red-Bed Soft Rock Subgrade Filler

Red beds (RBs) are widely distributed in all continents of the world. With the rapid development of road and railway construction, the construction of roads and railways in RB areas is increasing. However, when RB is the filler, it will expose three aspects of serious deficiencies in compaction, mechanical bearing capacity, and water stability, which will cause fatal harm to the subgrade. Therefore, RB has to be abandoned and cannot be used as a subgrade filler. In this paper, different microwave irradiation temperatures (DMITs) from room temperature of 25 degrees C to 700 degrees C were used to reveal the enhancing mechanism of RB in three aspects based on the analysis results of microscopic composition and structure. The microscopic composition and structure show that RB can be divided into a low-temperature section (25 degrees C-400 degrees C) and a high-temperature section (500 degrees C-700 degrees C) under the microwave condition. The low-temperature section has some improvement in the engineering performance of RB, but the influence is limited. The engineering performance of RB is improved completely in the high-temperature section. Specifically, the coarse size of RB increases with the rise in microwave temperature, which is beneficial for improving fine size. The compaction property of RB is not largely affected by the water content and can still meet the most stringent subgrade filler requirements, even under saturated conditions or 0. The California bearing ratio (CBR) value can maintain more than 20% under the ultimate working condition, far higher than the code requirements. The increase of internal friction angle and cohesion can enhance the stability of the cut slope, which is conducive to construction in remote mountainous areas. The water resistance of RB is positively correlated with the microwave irradiation temperature, especially at 700 degrees C; RB experiences secondary hardening after encountering water, the mechanical strength increases, and the softening coefficient reaches 107.44%. The research shows that after microwave high-temperature stabilization, the engineering characteristics of the RB are thoroughly strengthened, and it becomes a high-quality subgrade filler to eliminate the three diseases of RB subgrade completely. Compared with the traditional method of adding stabilizers, microwave in situ RB stabilization reduces the site construction's complexity, saves a lot of stabilizer use and transportation costs, and can effectively reduce carbon emissions. This study provides a positive perspective on the in situ application of the RB soft rock subgrade. It could be a starting point for understanding the microwave-based stabilization of soft rock soils subgrade filler in situ.