Low-cost BPO₄ In Situ Synthetic Li₃PO₄ Coating and B/P-Doping to Boost 4.8 V Cyclability for Sulfide-Based All-Solid-State Lithium Batteries

Structural damage of Ni-rich layered oxide cathodes such as LiNi0.8Co0.1Mn0.1O2 (NCM811) and serious interfacial side reactions and physical contact failures with sulfide electrolytes (SEs) are the main obstacles restricting >= 4.6 V high-voltage cyclability of all-solid-state lithium batteries (ASSLBs). To tackle this constraint, here, a modified NCM811 with Li3PO4 coating and B/P co-doping using inexpensive BPO4 as raw materials via the one-step in situ synthesis process is presented. Phosphates have good electrochemical stability and contain the same anion (O2-) and cation (P5+) as in cathode and SEs, respectively, thus Li3PO4 coating precludes interfacial anion exchange, lessening side reactivity. Based on the high bond energy of B-O and P-O, the lattice O and crystal texture of NCM811 can be stabilized by B3+/P5+ co-doping, thereby suppressing microcracks during high-voltage cycling. Therefore, when tested in combination with Li-In anode and Li6PS5Cl solid electrolytes (LPSCl), the modified NCM811 exhibits extraordinary performance, with 200.36 mAh g(-1) initial discharge capacity (4.6 V), cycling 2300 cycles with decay rate as low as 0.01% per cycle (1C), and 208.26 mAh g(-1) initial discharge capacity (4.8 V), cycling 1986 cycles with 0.02% per cycle decay rate. Simultaneously, it also has remarkable electrochemical abilities at both -20 degrees C and 60 degrees C.