Residual stress and microstructure control in welding of SA508 low alloy steel

Various types of solid-state phase transformation (SSPT) occur during the SA508 steel welding process, especially for multi-pass welding. The multiple thermal cycles lead to a more complex microstructure distribution and significantly influence the residual stress distribution. Therefore, to better control the microstructure and residual stress, it is necessary to optimize the process parameters which are closely related to the welding thermal cycles. This study established a thermo-mechanical-metallurgical multi-field coupling model and then validated it using X-ray and neutron diffraction residual stress measurement tests. Furthermore, the influence of welding heat input and preheating temperature on the formation of phase constituents and the ultimate residual stress field were analyzed in detail, concomitantly with a comprehensive discussion on their underlying mechanisms. The results showed that the increase of heat input expanded the domain occupied by the bainite phase, accompanied by the increase of compressive stress region. Moreover, the rise of preheating temperature promoted the bainite phase transformation, thus decreasing the longitudinal compressive stress and the stress gradient. The variation induced by welding parameters was closely related to the welding cooling rates. To obtain a full bainite and low residual stress condition of welded joint, it becomes imperative to exercise control over cooling rates, maintaining them at approximately 1.0 degrees C/s.