Study on Unsteady Flow Characteristics of Cooling Water Pump for Nuclear Power Plant Equipment under Low Flow Rate Conditions

During the operation of cooling water pumps, it is necessary to operate them under conditions of low flow rate. In order to improve the unstable performance of the cooling water pump under low flow rate conditions. Taking the cooling water pump as the research object, the internal flow and pressure pulsation characteristics of the cooling water pump under 0.4Q to 0.6Q conditions were investigated, and the influence of different operating conditions on the performance and vibration of the cooling water pump was analyzed. The ANSYS CFX 2022 software and the SST k-omega turbulence model were used to perform a three-dimensional numerical simulation of the cooling water pump. After analyzing the simulation results, the velocity and pressure cloud and streamline diagram within the semi-spiral suction casing and impeller were obtained. The internal flow state of the cooling water pump was then analyzed in detail under low flow rate conditions. At the same time, a series of monitoring points were set up within the impeller, and the pressure pulsation within the impeller was analyzed using the frequency domain diagram and the radial force polar coordinate diagram. The results show that at flow rates between 0.4Q and 0.6Q, a certain amount of vortex has been generated in the suction casing, which affects the flow state when entering the impeller. Furthermore, significant vortices have been generated in the middle and back part of the blade and mainly concentrated in the pump cover of the mid-open pump. At the same time, when in low flow rate conditions, the primary frequency of pressure pulsation is mainly the axial frequency, with three times the axial frequency and blade frequency following. The amplitude of the pressure surface (PS) of the blade is greater than that of the suction surface (SS) and increases as the flow rate decreases. The internal radial force corresponds with the result of pressure pulsation and exhibits a certain pattern. This study outlines the coolant pump's internal flow and pressure pulsation characteristics under low-flow conditions. It proposes a solution to stabilize the cooling water pump at low flow rates and provides theoretical guidance for optimizing its design.