Numerical analysis of flow and heat transfer characteristics of unsteady film cooling of HPT shroud under high-speed rotation sweeping of the rotor blade

3D URANS simulations were performed to investigate the influence of high-speed blade rotation sweeping effect on the unsteady multi-hole film cooling performance of a high-pressure turbine (HPT) shroud. The blade rotation speed was 10,000 rpm and 15,000 rpm, the associated Strouhal numbers (St) were 2.35 and 3.52, and the blow ratio (M) was varied from 0.5 to 1.5. The instantaneous and time-averaged characteristics of film outflow mass rate, pressure distribution, film cooling effectiveness (FCE), and convective heat transfer coefficient (CHTC) of the HPT shroud with and without impinging jets were determined. The results show that the St and M have a substantial impact on the distribution of the FCE and CHTC on the shroud surface. At a high St and M , the FCE on the shroud surface is greater and more sensitive to the rise in M. As St increases, the suppression effect of the tip leaking vortex (TLV) on film and FCE on the shroud surface improved. The increased impingement jet effect has minimal impact on the FCE of the shroud. Under a high-speed blade rotation sweep, the net heat flux on the shroud wall with impingement/film cooling falls by approximately 22% when compared to the uncooled shroud surface.