FIV and energy harvesting using bluff body piezoelectric water energy harvester with different cross-sections

Research utilizing piezoelectric fiber composites to power network nodes or micro-sensors by capturing energy from the surrounding environment is becoming a hot spot, and the structural design to efficiently improve the performance of energy harvesting is very important. The performance of a vertical cantilever piezoelectric water energy harvester (PWEH) with three different cross-sections including circular, square and equilateral triangle, each with a mass ratio of 4.8, was investigated at Reynolds number within 770-8800. Emphasis is placed on the effects of the bluff body cross-section, load resistance, and flow velocity on the flow-induced vibration (FIV) and energy response of the vertical cantilever beam of the PWEH. Except for the decreasing amplitude in the lower branch of the circular cylinder water energy harvester (CWEH), there is no distinction in the vibration response branches compared to the classical elastically supported circular cylinder. The resistance has little effect on the vibration response, while it has a significant effect on the voltage and power response. The maximum amplitude and pendulum angle of the square cylinder water energy harvester (SWEH) are slightly larger than those of the CWEH. The maximum voltage and power are smaller for the SWEH than for the CWEH. The equilateral triangular cylinder water energy harvester (TWEH) demonstrates excellent performance. It has a maximum amplitude of 3.8 D, 3.4 times that of the CWEH. The peak pendulum angle of TWCH is 13.9 degrees, 3.2 times that of CWEH. It has a voltage of 0.057 V at a resistance of infinity, which is 3.4 times that of CEWH. In addition, the TWCH has an output power of 0.38 nW at a resistance of 106 omega, which is 9.5 times that of the CWEH. This study suggests that the best energy efficiency of TWEH is achieved by coupling vortex-induced vibration (VIV) and galloping excitation.