Feasibility of Wave Simulation in Typhoon Using WAVEWATCH-III Forced by Remote-Sensed Wind

The purpose of our work was to assess the feasibility of hindcasting waves using WAVEWATCH-III (WW3) in a typhoon by assembling winds from multiple remote-sensed products. During the typhoon season in 2021-2022, the swath wind products in the Western Pacific Ocean were collected from scatterometers and radiometers. Cyclonic winds with a spatial resolution of 0.125 degrees at intervals of 6 h were obtained by assembling the remote-sensed winds from those satellites. The maximum wind speeds, Vmax, were verified using the reanalysis data from the National Hurricane Center (NHC), yielding a root-mean-squared error (RMSE) of 4.79 m/s and a scatter index (SI) value of 0.2. The simulated wave spectrum was compared with the measurements from Surface Waves Investigation and Monitoring (SWIM) carried out on the Chinese-French Oceanography Satellite (CFOSAT), yielding a correlation coefficient (Cor) of 0.80, squared error (Err) of 0.49, RMSE of significant wave height (SWH) of 0.48 m with an SI of 0.25, and an RMSE of the peak wave period (PWP) of 0.95 s with an SI of 0.10. The bias of wave (WW3 minus European Centre for Medium-Range Weather Forecasts (ECMWFs) reanalysis (ERA-5)) concerning the bias of wind (assembling minus ERA-5) showed that the WW3-simulated SWH with the assembling wind forcing was significantly higher than that with the ERA-5 wind forcing. Moreover, the bias of SWH gradually increased with an increasing bias of wind speed; i.e., the bias of SWH increased up to 4 m as the bias of wind speed reached 30 m/s. It was concluded that the assembling wind from multiple scatterometers and radiometers is a promising source for wave simulations via WW3 in typhoons.