Effect of Build Orientation on Anisotropy in Tensile Behavior of Laser Powder Bed Fusion Fabricated SS316L

In the present study, Stainless steel 316L (SS316L) cylindrical specimens were fabricated at two different build orientations and two different laser powers using Laser powder bed fusion process (LPBF). Microstructural characterization such as XRD, SEM, EBSD analysis and tensile testing were carried out on fabricated specimens in stress relieved condition to understand the anisotropic behavior of LPBF printed specimens. Horizontally oriented specimens showed higher tensile strength when compared to vertically oriented specimens for both laser powers. XRD and EBSD phase maps did not reveal the presence of any secondary phases. However, build orientation and laser power affected the crystallite size of the samples. Bimodal grain structure comprising coarse columnar grains and fine equiaxed grains were observed from the micrographs. With variation in build orientation, there was a significant change in the average grain size of the specimens. High dislocation density was observed in horizontally oriented samples built at low laser power because of dislocation annihilation that can occur at high temperatures. However, EBSD analysis revealed random weak crystallographic texture which does not vary significantly with laser power or build orientation. Variation in grain size, grain morphology, sub-grain features and dislocation density are the reasons for the anisotropic tensile behavior observed in LPBF printed SS316L coupons in stress relieved condition.