Development of an accurate optical sensor for the in situ real-time determination of the chemical oxygen demand of seawater

Chemical oxygen demand (COD) is an important indicator for monitoring the quality of seawater. The COD of seawater reflects the levels of organic pollutants in the water. Methods that are commonly used to measure the COD of seawater have high accuracy, good repeatability, and low costs. However, using them for the in situ real-time monitoring of the COD of seawater is unfavorable because they require complex procedures and a long measurement time and may cause pollution to the environment. This paper reports on an optical sensor that accurately determines the COD of seawater in situ. The COD determination is based on the absorption of ultraviolet and visible lights with different wavelengths by organic matter in the water. Single-point LEDs emitting lights with different wavelengths (254, 265, 280, and 546 nm) were used as sources of excitation lights, and photodiodes were used as receiving devices. The optical system, circuit system, and mechanical structure of the sensor were efficiently integrated. The inversion of the COD of seawater was obtained after turbidity correction using the multiple linear regression algorithm. The maximum measurement error, detection limit, and repeatability of the sensor were 5%, 0.05 mg/l, and 0.62%, respectively. Moreover, the R-2 values for correlations between COD values and absorbance values measured at three wavelengths (254, 265, and 280 nm) were above 0.99. Overall, the sensor is suitable for the in situ real-time monitoring of the COD of seawater. It requires a short measurement time and generates no pollution.