Deformation-Based Basal Heave Reliability Analysis and Selection on Monitoring Points for General Braced Excavations
SUSTAINABILITY(2023)
Abstract
A framework for evaluating deformation-based basal heave stability is proposed in order to distinguish between the different responses under freely developed and prohibited basal heave failures. In the case of freely developed basal heave failure, the maximum deformation values occur at the center point of pit bottom, whereas this is not the case for the prohibited basal heave failure. The critical thickness of soft soil layer between the end of supporting structures and the top of hard stratum is about 0.3B (B = excavation width), beyond which the freely developed basal heave failure arises. In situations otherwise, the prohibited basal heave failure occurs. The failure probability of basal heave failure at the center point increases significantly as B ranges within a limited value; then, it begins to decrease or to vary slightly at a certain value under a given thickness of soft soil layer. If the thickness of soft soil layer is so sufficiently large that freely developed basal heave failure occurs for any of B, the failure probability of basal heave failure at the center point increases as B increases. The selection of the optimum monitoring points for basal heave stability is recommended to account for the weights in the contribution to the basal heave deformations of the influencing factors such as excavation width and thickness of soft soil layer. The proposed framework is applicable to basal heave reliability analysis for braced excavations where deformation values are focused.
MoreTranslated text
Key words
basal heave stability,basal heave deformation,monitoring points design,response surface method,Monte Carlo simulation
AI Read Science
Must-Reading Tree
Example
![](https://originalfileserver.aminer.cn/sys/aminer/pubs/mrt_preview.jpeg)
Generate MRT to find the research sequence of this paper
Chat Paper
Summary is being generated by the instructions you defined