Effect of tool tilt angle on microstructure, mechanical properties and fracture behavior of dissimilar friction stir lap welding joint of SiCp/ZL101 and ZL101

In order to achieve the lightweight goal of urban rail train braking system, friction stir lap welding (FSLW) was used to weld SiCp/ZL101 and ZL101 sheets to prepare a new type of brake disc material. The effects of different tool tilt angles (TTAs) on microstructure and mechanical properties of the welding joints were systematically studied. The TTA had a significant effect on the microstructure and defect formation of the dissimilar FSLW joints. There were tunnel defects under the advancing side at 1 degrees and 2 degrees. Internal defect-free weld structures were formed at 3 degrees and 3.5 degrees. A large number of dislocations caused by plastic deformation remained in the microstructure of the weld region at 1 degrees and 2 degrees, and the transformation of the microstructure of the weld region at 3 degrees and 3.5 degrees was dominated by dynamic recovery and dynamic recrystallization. The distribution of SiC particles in the nugget area was uniform, and the grains were obviously refined. With the increase of the TTA, the average grain size of the nugget area increased, the average size of the SiC par-ticles decreased, and the average hardness of the nugget area increased. The four samples all formed a transition zone with good metallurgical bonding at the welding interface. The shear strength of the welding joints increased first and then decreased with the increase of the TTA. In the absence of welding defects, the shear strength reached the best level of 130.71 MPa at 3 degrees. Both shear and tensile fractures were ductile fractures. (c) 2023 The Author(s). Published by Elsevier B.V. This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).