Increasing the recovery and selectivity of 238U, 235U, and 234U extraction with tri-n-butyl phosphate in mine tailing samples with a high copper content

Abandoned Cu mine tailings may be associated high concentrations of U. However, the presence of stable cations such as Cu, Fe, Al, Ca, or Mg, etc. in high concentrations can reduce the chemical efficiency of the liquid–liquid extraction method with tri-n-butyl phosphate (TBP); it can also inhibit the electrodeposition of U on the stainless steel planchet where the sample is measured. In this work we studied an initial stage of complexation with ethylenediaminetetraacetic acid (EDTA) and a back extraction with different solutions: H2O, Na2CO3, and (NH4)2CO3 at room temperature and at 80 °C. The sensitivity of the method was 4.9·10−4 Bq for 238U and 234U, and 2.3·10−5 Bq for 235U. The validation of the method achieved 95% of the results when using a |ζ-score| ≤ ± 2.0 and a relative bias (RB[%]) ≤ ± 20% as the acceptance criteria. The recoveries obtained with the proposed method were higher than those achieved with the extraction method without initial complexation and re-extraction with H2O for water samples. Finally, this method was applied in practice to study the tailing of an abandoned Cu mine and the activity concentrations of 238U and 235U were compared with those obtained by gamma spectrometry for 234Th and 235U. The means and variances of both methods showed no significant differences between these two isotopes.