Improved corona discharge-based modified poling method for 0-3 PZT/ PEGDA

Among piezo composites, 0-3 type ceramic/polymer-based composites have balanced properties and flexible manufacturing processes, allowing them to tackle challenges in wearable electronics and sensing technology. However, due to a misfit between the dielectric coefficients of the ceramic particles and polymer matrix, poling 0-3 composites is difficult. Therefore, in this study, we develop a novel poling method that combines the merits of normal corona poling and oil-based poling methods to activate a lead zirconium titanate (PZT)/Polyethylene glycol diacrylate (PEGDA) composite. The influence of various parameters (voltage, temperature, poling dura-tion, and time of ageing) on the piezoelectric and dielectric properties of the PZT/polymer composite were evaluated. For the 0-3 PZT/PEGDA composites (67 wt%), the optimal poling parameters were found to be 60 min poling duration, 25 degrees C, and 24 kV. The d33 (32 pC/N) obtained by the proposed poling method is about 3 times that obtained by the normal corona poling method (11 pC/N). This modified poling method was shown to be more effective than the conventional method for a range of filler contents (50 wt%, 67 wt%, and 75 wt%). It was also found that the d33 value of the PZT/PEGDA composite increased over time and was attributed to the increase of the composite dielectric constant after poling. Finally, sensing elements were assembled from the poled samples and evaluated, which shows the potential for detecting tiny signals in sensing and soft robotics.