Leakage Dynamics of Glass Bottles on Container Closure Integrity Testing: Influence of Different Laser-Drilled Microhole Geometries.

Container closure integrity testing (CCIT) is a critical step in ensuring package integrity and providing feedback on package designs. In practical applications, CCIT methods, namely physical and probabilistic methods, must be appropriately selected and validated to ensure their suitability for the intended use. However, the industry still lacks practical recommendations regarding the choice of CCIT methods and artificial leaks to set the acceptance criteria. The main reason is the lack of correlation between testing methods. Artificially introduced leak microholes are the only way to determine the sensitivity of a CCIT method and to implement the method correlation. However, the type of artificial leakage is a key factor because in most studies, leakage is described and valued using a single parameter, such as size. This can significantly affect the credibility of the relevant test results, especially in the case of microbial invasion, where the difference in test conditions and samples will severely affect the probability of microbial invasion. Therefore, it is vital to conduct a systematic study on the influence of leakage conditions on CCIT methods. In this study, the influence of the shapes of artificial leaks on the two kinds of testing methods was systematically studied based on a laser-drilled microhole-a highly potential and non-exogenous artificial leak manufacturing method that can fabricate different leakage geometries. The reason for the influence of the shape of an artificial leak on the CCIT is that the deterministic method takes defects as an idealized model and ignores the influence of the leak shape, wall thickness, and other factors on leakage and pollution risks. However, these factors seriously affect the dynamic process of leakage and microbial invasion. The pressure decay method is used to test the leakage flow rate of conical and straight holes. Microbial challenge tests are then used to verify the impact of leakage shapes on the pollution risk. The results of the tests indicated that the probability of microbial invasion in the conical holes is much higher than that in straight holes with the same flow test results and that the wall thickness can also affect microbial invasion. Thus, it can be proven that the risk of leakage and invasion or the sensitivity of different methods cannot only be compared through the leak diameter. Numerous influencing factors, including leakage geometry (e.g., shape and thickness), must be considered in practical applications.