Synthesis of Ce-Ni/sepiolite with excellent adsorption and catalytic oxidation performance toward dyes

A novel and highly efficient wastewater treatment process for the removal of industrial dyes was proposed in this study. The method involved the regeneration of Ce-Ni/sepiolite, which acted as an adsorbent/catalyst, exhausted with the cationic dye auramine O (AO)-a frequently-used industrial dye-under a stream of O-2 hot gas. The Ce-Ni/sepiolite adsorbent/catalyst was successfully synthesized by impregnation and was characterized by XRD, SEM, XPS, and BET techniques. An orthogonal experimental design method was applied to optimize the synthesis conditions of Ce-Ni/sepiolite. These synthesis conditions used the regeneration efficiency/rate of the catalyst as the evaluation index under heated O-2 gas stream regeneration. Ce-Ni/sepiolite exhibited remarkable adsorption and catalytic oxidation degradation qualities for AO. The regeneration rate of as-prepared Ce-Ni/sepiolite reached 112.9% after 1 hour at 500 degrees C under 6 L min(-1) of hot gas. The batch adsorption capacities were found to be 210.60 mg g(-1) (25 degrees C), 243.90 mg g(-1) (35 degrees C) and 263.16 mg g(-1) (45 degrees C). 45 degrees C seemed to allow for the optimum adsorption capacity. Ce-Ni/sepiolite also showed high dynamic adsorption capacity, able to treat 48 bed volume (BV) of the dye solution with a residual concentration of 0 mg L-1 when the height to diameter ratio is 2.5. The adsorption and regeneration mechanisms were proposed. The as-synthesized Ce-Ni/sepiolite can be used as an efficient adsorbent and catalyst in wastewater treatments. This further supports the prospective usability of the sepiolite adsorbent for dye removal in future industrial applications.