Study on low-temperature plasma -Al₂O₃ catalytic viscosity reduction of polyacrylamide solution

The wide use of polyacrylamide (PAM) in enhanced oil recovery generates a large amount of polymer-bearing wastewater featuring high viscosity and difficult viscosity reduction, making the treatment of wastewater increasingly difficult. In this paper, the experimental study on reducing the viscosity of wastewater containing polyacrylamide by using the plasma generated by dielectric barrier discharge (DBD) and the synergistic effect of catalyst gamma-Al2O3 is carried out. The law of plasma reducing the viscosity of wastewater containing polyacrylamide is studied under the different conditions of amounts of gamma-Al2O3 catalyst, discharge voltages, and initial concentrations of polyacrylamide-containing wastewater. The mechanism of viscosity reduction of polyacrylamide is studied through environmental scanning electron microscope (ESEM), Fourier transform infrared (FTIR) spectrometer, and X-ray photoelectron spectroscopy (XPS). The results show that the catalytic viscosity reduction is the best when the discharge voltage is 18 kV and the discharge time is 15 min. With the increase in the input of the gamma-Al2O3 catalyst, the viscosity of the PAM solution decreases gradually. When the amount of gamma-Al2O3 is 375 mg, the shear rate changes from 0.5 1/sec to 28 1/sec, and the viscosity of the solution containing polyacrylamide changes from 434.5 mPa & BULL;s to 40.2 mPa & BULL;s. The viscosity reduction rate of the PAM solution is 90.7%. After the catalytic viscosity reduction, the functional groups of polyacrylamide do not change much. The elemental composition of the catalyst has not changed, which is still Al, C, and O.