Process Optimization of Non-Holonomic Surface Milling for Al-Si7Mg Component

Milling process enhancement for an aluminium alloy component with a large bore and variable wall thickness for incomplete circular surfaces, research on the optimization of milling process parameters based on machining stability and machining deformation control was carried out. Analysis of the formation mechanism of the regeneration effect caused by casting defects in cast aluminium parts, the stability lobe diagrams are plotted by the zero-order frequency domain analysis method, and the effects of radial depth of cut, cis-reverse milling and the dynamics parameters of the milling system on the boundary range of the stability lobe diagram were investigated. By orthogonal simulation analysis of milling deformation, determine the primary and secondary relationship between the influence of each process parameter on the machining deformation and the optimal combination of each process parameter in the test range. The results show that in the milling process, reducing the radial depth of cut, using a more rigid milling cutter and reverse milling can all be effective in improving the stability of the process; The significant influence of process parameters on the amount of machining distortion is: radial depth of cut > feed rate > cutter’s speed, the optimal combination of process parameters is: cutter’s speed 600 r/min, radial depth of cut 0.2 mm, feed rate 150 mm/min.The process parameters are used for machining verification, the surface roughness of the annular hole was improved from 6.3 to 3.2 before the optimization, and the coaxiality was improved from 0.12mm to 0.05mm before the optimization. The results show that Optimised milling process parameters improve part quality.