Sensitivity of electrical behaviours of ZnO nanoparticle-Bi2O3-Mn2O3 varistor system to various La2O3 doping compositions

The effects of La2O3 on the behaviours of ZnO nanoparticle-Bi2O3-Mn2O3 varistors were determined. The discs with various La2O3 compositions (0.0-3.0 mol%) were prepared via traditional ceramic techniques and their characteristics were investigated. The results demonstrate that La2O3 remarkably affects the varistor samples, in which the size of grain diminished from 29.3 to 8.5 mu m according to increasing La2O3 content from 0.0 to 3.0 mol%. The significant response within the varistor sample fabricated from ZnO nanoparticles through sintering process at 1200 degrees C perhaps caused by the surface properties of the powdered ZnO nanoparticles. X-ray diffraction results show that the addition of La2O3 to the varistor resulted in additional peaks, which can be attributed to the construction of La-based phases through the sintering process at high temperature. The spinal phases of the (Bi48ZnO73) and (Mn3O4) diminish with the 3.0 mol% content of La2O3. The varistor samples with 2.0 mol% La2O3 show a superior spinal phase construction of (Bi48ZnO73) and (Mn3O4) and La-based phases, resulting in homogeneous grain size. La2O3 doping substantially enhanced the electrical behaviours of the disc sample with a notable increase in breakdown voltage from 2614.8 to 5730.7 V/mm caused by the increase in La2O3 doping concentration from 0.0% to 3.0 mol%. The improvement was associated with the potential lanthanide ion segregation caused by its greater ionic radius to the boundaries between ZnO grains, thus enhancing its electrical properties. Moderate La2O3 doping concentration at 1.0 mol% improved the non-linear characteristics of the sample (alpha = 66) and 4400 V/mm breakdown voltage was introduced, while a significant amount of La2O3 doping concentration (more than 1.0 mol%) caused its deterioration (alpha = 35). The increase in donor concentration N-d to 2.1 x 10(20) cm(-3) for the varistor doped with 1.0 mol% La2O3 is accompanied by a decrease of interfacial states density N-IS to 2.2 x 10(12) cm(-2) eV(-1), i n addition to decrease in depletion layer omega to 3.9 nm. The leakage currents of the sample decreased from 0.473 to 0.310 mA/cm(2) with the increase of La2O3 doping contents from 0.0% to 2.0 mol% and then increased to 0.596 mA/cm(2) at 3.0 mol% La2O3 doping concentration. Therefore, La2O3 may be added to dominate the microstructural characteristics and electrical behaviours of ZnO-Bi2O3-Mn2O3 varistor manufactured using powdered ZnO nanoparticles.