Microwave Sol-gel Synthesis of Co, Ni, Cu, Mn Ferrites and the Investigation of Their Activity in the Oxidation Reaction of Carbon Monoxide

Background: The study effect of microwave radiation on the catalytic properties of transition metal ferrites synthesized by ceramic and sol-gel methods in the oxidation reaction of carbon monoxide into dioxide. Objective: This work aims to study the effect of microwave radiation on the production of cobalt, copper, nickel, and manganese ferrites by sol-gel combustion technology using various organic reagents and to study their catalytic activity in the oxidative conversion of carbon monoxide into dioxide. Methods: Microwave treatment was carried out on a setup based on an EM-05593V microwave oven (Panasonic) with a magnetron power varying from 300 to 800 W with an operating frequency of 2450 MHz. X-ray phase analysis of the products was carried out on a Bruker D 2Phazer automatic diffractometer. The measurement of the specific surface area of the samples was determined by low-temperature nitrogen adsorption by the multipoint BET method on a SORBI-MS instrument (ZAO META, Russia). IR spectra were recorded using FT-IR LUMOS Bruker spectrometers. The micrographs of samples were analyzed on the Sigma VP (Carl Zeiss Jena) equipment. Results: It was determined that the most active catalysts for the oxidation of carbon monoxide to dioxide are ferrites obtained by the sol-gel combustion method using microwave radiation to "ignite" the gel. Conclusion: The use of microwave radiation in the preparation of ferrites by the sol-gel method with combustion can initiate a self-propagating exothermic combustion reaction in the entire volume of the sample in a very short time, measured in seconds. The catalytic activity in the oxidative conversion of carbon monoxide obtained by this method of ferrites is comparable to the activity of ferrites obtained by the sol-gel method with traditional combustion.