Study on Dynamic Response Characteristics of Stepped Reinforced Retaining Wall
BUILDINGS(2022)
Abstract
In order to further explore the influence of reinforcement materials laying position on the dynamic characteristics of reinforced retaining walls, based on FLAC3D finite difference methods for solving nonlinear problems, established with the same size of the retaining wall in practical engineering, the reinforcement material's relative position in the retaining wall for the normalized processing, under seismic load, and the panel under the conditions of different reinforcement arrangement were analyzed, and the horizontal displacement of slope, the vertical and horizontal earth pressures behind the wall, and the distribution of potential sliding surface were calculated. The relationship between the maximum horizontal displacement of the panel and the laying position of the reinforcement was fitted by MATLAB. The results show that the horizontal displacement of the panel is about 40% smaller when the upper layer of the reinforcement is arranged than that in the lower layer for step 1, and the horizontal displacement of the reinforcement in step 2 is about 30% lower than that in other conditions when the reinforcement is arranged at the top of the slope. The reinforcement arranged in the lower layer of step 1 and the upper layer of step 2 can minimize the wall top displacement. In step 1, the vertical earth pressure and horizontal earth pressure are 19% and 5% smaller than those in other conditions when the reinforcement is arranged near the middle and lower layer of the step. In step 2, the difference between vertical and horizontal earth pressure is not obvious, and the difference between the two conditions is controlled within 5%. At the same time, soil liquefaction and uplift occur under the action of earthquake. The position of sliding crack surface has no obvious regularity with the position of reinforcement, but the position of reinforcement at the step classification is obviously better than other conditions. The fitting formula can describe the relationship between the panel displacement and the position of the reinforcement well. The conclusions can provide a point of reference for practical engineering.
MoreTranslated text
Key words
reinforcement position,normalized processing,seismic load,panel displacement,earth pressure,critical slip surface
AI Read Science
Must-Reading Tree
Example
![](https://originalfileserver.aminer.cn/sys/aminer/pubs/mrt_preview.jpeg)
Generate MRT to find the research sequence of this paper
Chat Paper
Summary is being generated by the instructions you defined