Effect of growth rate and pH on Li isotope fractionation during its incorporation in calcite

Lithium isotope compositions were determined for synthetic calcite and fluid, reported in Füger et al. (2019). Calcite was precipitated at 25 °C, and mineral growth rate and pH varied within the range of 10−8.1 ≤ rp (mol m−2 s−1) ≤ 10−7.2 and 6.3 ≤ pH ≤ 9.5, respectively. At pH = 8.25 ± 0.15, the Δ7Licalcite-fluid = δ7Licalcite - δ7Lifluid value of −2.76 ± 0.22‰ (n = 4) was yielded when calcite growth rate was lower than ∼ 10−7.7 (mol m−2 s−1). As calcite growth rate increased, Δ7Licalcite-fluid values progressively decreased to about −4.5‰. The dependence of Li isotope fractionation on calcite growth rate is described by the surface reaction kinetic model developed by DePaolo (2011). In this model the equilibrium and kinetic isotope fractionation factors obtain values of −2.7 ± 0.1‰ and −8.8 ± 0.1‰, respectively. In addition, for experiments performed under similar surface-normalized growth rate of 10−7.7±0.2 (mol m−2 s−1) a significant decrease in Δ7Licalcite-fluid from pH 9.5 to 6.3 was observed. These variations of Δ7Licalcite-fluid as a function of pH for experiments performed under low degrees of solution saturation with respect to calcite point towards the incorporation of two or more Li-bearing species in the solid phase. Thus, the Li isotope composition of the solid reflects the abundance of these species, which depends on solution pH and fluid composition.