Thermal Effect on Thin-Film Formation of the Polymer Sheets by the CO2 Laser with the Copper Base

A method that makes polymer sheets partially thinner with continuous-wave carbon dioxide (CO2) lasers has been developed. This method can create thin polymer films by attaching the polymer sheets to the copper base by vacuum suction through the holes in the base. Applying the method to polypropylene (PP), polyethylene terephthalate (PET), polystyrene (PS), and polytetrafluoroethylene (PTFE), the thin-film formation is confirmed in PP, PET, and PS but not PTFE. These polymers have the similar thermal properties. PP, PET, and PS show fluidity with increased temperature, but PTFE does not have fluidity. These characteristics of the polymers indicate that the fluidity of polymer is the important characteristic for film formation. The experiments with PP and PET sheets of different thickness show that thicker sheets make thicker films. The fluid flow of the molten polymer is considered to form the thin film at the bottom of the groove made by laser scribing. The numerical simulation of the 2D thermal model also indicates the week cooling effects of the base on the film formation and importance of polymer fluidity. The results of Fourier transform infrared spectrometer (FT-IR) show thermal degradation of the films. To decrease the heat's effect on the films, the polymer sheets should be processed at the highest laser-beam scanning speed that can make thin films.