Microstructures and deformation mechanisms of the medium-entropy alloy (NiCoCr)76(Ni6AlTi)3

The microstructures and deformation mechanisms of the f.c.c. medium-entropy alloy (MEA) (NiCoCr)76(Ni6AlTi)3 has been analyzed after various thermo-mechanical treatments. The solutionized, single-phase MEA, which had a grain size of 93.4 ± 31.9 μm, was cold-rolled (CR) to a 80% thickness reduction after which it showed both a high yield strength (YS) of 1539 MPa and a high ultimate tensile strength (UTS) of 1602 MPa, but an elongation to failure, ε, of only 16%. The CR MEA was then subjected to one of two heat treatments: (1) the CR MEA was recrystallized at 1100oC for 24 h, which produced a single-phase material with 85 ± 61.7 μm grain size that exhibited a much lower YS and UTS of 364 MPa and 747 MPa, respectively, but a much greater ε of 73%; and (2) the MEA was aged at 700oC for 24 h, which produced a fine-grained (1.1 ± 0.9 μm) material and a high volume fraction (0.35) of 12 nm dia. L12 nanoparticles that exhibited an excellent combination of strength and ductility, viz., YS∼1501 MPa, UTS∼1651 MPa, elongation ∼26%. The grain boundary strengthening and precipitation strengthening were together estimated to account for ∼58% of the YS in the latter material. After deformation, the recrystallized MEA contained numerous stacking faults and a Taylor lattice structure containing domain boundaries and microbands, while the aged MEA exhibited numerous stacking faults and sheared particles. The density of low-angle grain boundaries (LAGBs) in the recrystallized MEA increased by 100 times to 2.2 × 10−1 μm/μm2 while the density of CSL Σ3n boundaries decreased by 71% to 7.8 × 10−3 μm/μm2 after deformation. In contrast, the density of LAGBs in the aged MEA increased by 5 times to 2.6 μm/μm2 while the density of CSL Σ3n boundaries decreased by 57% to 0.6 μm/μm2 after deformation.