Seesaw-type modulation of secondary electron emission characteristics of polytetrafluoroethylene-MgO composite coating

The electrostatic discharge (ESD) from polymer insulators is one of the environment-related anomalies on spacecraft. Theoretically, to mitigate the ESD effects, we could modulate the secondary electron yield (SEY, sigma) close to 1 in the entire energy range, suppressing surface charges. However, no single polymer insulator has been reported to achieve this seesaw-type modulation of SEY. Here, we exploringly designed and prepared MgO particles doped polytetrafluoroethylene (PTFE) composite coating to achieve this goal, which exhibits not only the reduced SEY characteristic of the microstructured PTFE coating at low energy but also the enhanced SEY characteristic of the double-layer structure of PTFE and MgO at high energy. The simulation and experiment results demonstrate that MgO particles doped PTFE coating achieves this seesaw-type modulation of SEY. The optimal MgO concentration is 20%, where the maximum SEY (sigma(max)) changes from 2.0 to 1.1; the SEY at 10 keV (sigma(10k)) changes from 0.6 to 0.8, and the higher energy of the SEY equal to 1 (E-p2) increases from 4.5 to 6.5 keV. The discharge test of the microstrip antennas with PTFE-MgO composite coating in a scanning electron microscope verifies the role of the seesaw-type SEY modulation in surface charge suppression. This study supplies an essential reference for suppressing surface charges on vacuum electronics based on modulation of secondary electron emission characteristics.