Laboratory Measurements Mapping Heterogeneity and Variation of Poroelasticity for Improved Hydraulic Fracture Design in a Tight Carbonate Reservoir Onshore UAE

Abstract Reservoir X is a thin and tight carbonate reservoir with thin caprock that isolates it from an adjacent giant reservoir. An accurate geomechanical model with high precision is required for designing the optimum hydraulic fracture and preventing communication with adjacent reservoirs. The reservoir exhibits considerable variability in rock properties that will affect fracture height growth, complexity, and width and rock interaction with treatment fluids. The heterogeneity observed from the tight sections is further complicated by the variation of Biot's poroelastic coefficient, α, which is required for accurate assessment of the effective stresses. Laboratory testing was required to characterize the extensive vertical heterogeneity for key inputs in developing a geomechanics model. Approximately 120 ft of continuous core from an onshore field was provided for this study. The core material represented a potential tight carbonate reservoir interval and bounding sections. Heterogeneity mapping was performed from continuous core measurements from CT-imaging and scratch testing. CT-imaging provides an indication of the bulk density variation and compositional changes. Scratch testing provides a continuous measure of the unconfined compressive strength (UCS). Combining the two provides a means for accurate definition of rock thickness for dense, moderately dense, and lower density material coupled with corresponding compressive strength. Rock units were then subdivided based on these continuous properties for further geomechanics tests. Using log analysis combined with continuous UCS measurements from scratch testing, eight rock type classes were defined covering the target reservoir interval and bounding sections. This information was used for optimizing the sample selection process to characterize each identified rock unit. Routine core analysis measurements reveal significant vertical heterogeneity with porosity ranging from 0.1% to 18.1%. Similar variability was determined from elastic properties for each of the eight rock types. Quasi-static values for Young's modulus and Poisson's ratio determined at in-situ stress conditions ranged from 2.6 to 9.6 × 106 psi, and from 0.16 to 0.34, respectively. The Biot's poroelastic coefficient has a first-order impact on the calculated effective stress profile, which directly affects fracture stimulation model results. Testing from this study combined with previous measurements (Noufal et al. 2020, SPE-202866-MS) provides a unique correlation with porosity and bulk compressibility. In addition, rock-fluid compatibility was evaluated with proppant embedment/fracture conductivity tests. Results are dependent on a given rock type, exhibiting a wide range of fracture conductivity as a function of closure stress from 10 to 1000 md-ft. Embedment for all cases was low to moderate.