The Mechanism of Porcelain Toughened by Activated Kaolinite in a Lower Sintering Temperature

A high sintering temperature is usually required to acquire excellent performance in the ceramic industry, but it results in high fuel consumption and high pollution. To reduce the sintering temperature and to toughen the porcelain, a self-produced sintering additive of citric acid activated kaolinite was added to the raw material; X-ray powder diffraction (XRD), transmission electron microscope (TEM), scanning electron microscope (SEM), and thermal gravity analysis and differential scanning calorimetry (TG-DSC) were used to characterize the samples, and the toughening mechanism was discussed. The citric acid activated kaolinite obtained high activity and a large specific surface area. After introducing the activated kaolinite, the bending strength of porcelain at 1270 degrees C increased from 100.08 MPa to 124.04 Mpa, which was 11.45% higher than that of porcelain without activated kaolinite at 1350 degrees C. The results of XRD revealed that the content of mullite increased and the quartz decreased at 1270 degrees C, and the well-distributed needle-like mullite was observed in the images of SEM with the addition of citric acid activated kaolinite. The TG-DSC results indicated adding activated kaolinite to porcelain raw materials reduced the formation of mullite to 994.6 degrees C. The formation of mullite in a lower temperature served as mullite seeds in a green body during firing, and it enhanced the growth of mullite. These contributed to the appropriate phase composition and the excellent microstructure of porcelain. Thus, the distinguished mechanical performance of porcelain was obtained. Moreover, the sintering additive had no adverse effect on the porcelain body as citric acid-activated kaolinite was one of the main components of the porcelain raw material.