Mechanical Properties of Lamellar Shale Considering the Effect of Rock Structure and Hydration from Macroscopic and Microscopic Points of View

It is well known that the effect of shale hydration causes wellbore instability due to water phase invasion of drilling fluid to lamellar shale rich formations. This is because of that the mechanical properties (compressive strength, elastic modulus, etc.) of lamellar shale surrounding the borehole, which is rich in clay minerals, will decrease significantly after hydration. In this study, using the lamellar shale in the continental stratum of the southern Ordos Basin, the mechanical properties of lamellar shale were studied by compression tests considering the effect of lamellar structure and hydration from a macroscopic point of view. In addition, the mechanical mechanism was discussed combined with the CT scanning tests results from a microscopic point of view. The results demonstrate the following points. Lamellar shale has stronger anisotropy than bedding shale, the compressive strength (deviatoric stress) and elastic modulus of lamellar shale are both lower than those of bedding shale, and it is more prone to tension fracture. With the increase in the angle (beta) between the lamina and the axial direction from 0 degrees to 90 degrees, the compressive strength of lamellar shale decreases when beta < 30 degrees and then increases, the elastic modulus of lamellar shale decreases greatly when beta < 30 degrees and then tends to flatten. With the increase in hydration time, the compressive strength and elastic modulus of lamellar shale both gradually decrease, and the rates of their decrements reduce. The mechanical properties of lamellar shale are more affected by hydration than those of bedding shale. The hydration of lamellar shale leads to the formation of new fractures and the expansion of existing fractures in the junction area between the laminae and rock matrix, resulting in easy tension fracture along the laminae of shale.