Evaluation of the use of flotation for the separation of ground printed circuit boards

The paper presents an assessment of flotation efficiency in the separation of plastics from metals derived from printed circuit boards (PCBs). The PCBs were ground in a knife mill prior to flotation. The contact angles of various materials corresponding to the grains from ground PCBs were measured, and a series of flotation tests was carried out to obtain the best product. The impact of the following parameters were investigated: the reagent and its dose, the airflow rate through the flotation tank and the feed concentration. The highest efficiency of metal recovery from PCBs was achieved for Dimethoxy dipropyleneglycol at a concentration of 157 mg/dm(3) and with an airflow of 200 dm(3) /h and a feed concentration of <50 g/dm(3). In the hydrophilic product (concentrate), it was mainly Cu (40%) and Sn (7.8%) that were identified by means of XRF, but there were also trace amounts of precious metals such as Au (0.024%), Ag (0.5797%) and Pd (149 ppm). Impurities in the form of Si (5%), Ca (3.2) and Br (2.1) were also identified in this product. Small amounts of metals in their metallic form were identified in the hydrophobic product (waste), mainly Cu (2.3), Al (1.7) and Sn (1.1). As a result of the research, high recovery ratios were obtained for Cu (93%), Sn (84), Ag (83) and Au (69). The purity of obtained metal concentrate with this method was lower in comparison with the other methods of the recovery of metals from ground PCBs for the same feed, i.e. electrostatic or gravity separation. Also considering other factors such as the environmental impact of the flotation process, the number of facilities and their energy consumption, this process should not be used in the developed metal recovery technology. Using electrostatic separation for the same feed obtained much better results.