Analysis of the outer surface geometry on drawn tubes

Manufacturing Technology(2020)

Cited 3|Views2
No score
Abstract
Technological conditions of tube drawing influence the properties of the resulting products. In addition to mechanical properties, they also affect the geometry of the drawing tube - macro geometry and microgeometry. The paper presents the results of measurements of macro geometry (roundness and cylindricity) and micro geometry (surface roughness) of the outer surface of the drawn tube. Tubes (STN 41 1353) were drawn through dies with different reduction angles (6 degrees and 12 degrees). On used fixed mandrels were ground the straight and spiral grooves. The effect of these grooves and hence the deformation itself has also been manifested on the outer surface of the drawn tube. On the measured roundness profiles are significantly noticeable places where the land and the groove were when drawing. This effect can also be observed on the deteriorated measured values of roundness. On the measured values and roughness profiles of the outer surface of the drawn tube can also be observed the difference between land and grove.
More
Translated text
Key words
drawn tubes, roundness, cylindricity, surface roughness
AI Read Science
Must-Reading Tree
Example
Generate MRT to find the research sequence of this paper
Chat Paper
Summary is being generated by the instructions you defined