Advances in Temporary Bonding and Debonding Technologies for use with Wafer-Level System-in-Package (WLSiP) and Fan-Out Wafer-Level Packaging (FOWLP) Processes

Abstract Today's complex fan-out wafer-level packaging (FOWLP) processes include the use of redistribution layers (RDL) and reconstituted wafers with epoxy mold compound (EMC) for use in heterogeneous integration [1]. Wafer-level system-in-package (WLSiP) uses fan-out wafer-level packaging (FOWLP) to build the system-in-package (SiP) by attaching know-good die (KGD) in a chip-first process to a tape laminated temporary carrier. If the dies are attached in a die-up configuration (active area facing up) and then over-molded with EMC, contact pads on the embedded die are exposed during the backside grind process. During the RDL build, the temporary carrier supplies mechanical support for the thinned substrate. In a die-down configuration with the active area facing down (eWLB), the temporary carrier is removed after the molding process thus exposing the contact pads for RDL build and solder ball mount. The ideal chip attachment scheme should minimize lateral movement of the die during over-mold (die shift) and also minimize vertical deformation of the bonding material. Thermal release tape provides a convenient way to attach die to a carrier prior to over-molding with EMC. However, not all bonding materials are suitable for presentation in tape form, so the material used in the tape may not be the optimal choice. An alternative method is to directly apply temporary bonding material to the carrier substrate. This enables the use of bonding materials with higher melt viscosity and improved thermal stability, resulting in less vertical deformation during die placement, and reduced die shift during over-molding. The bonding material will ideally have high adhesion to the EMC wafer to prevent delamination in the bond line during downstream processing. Stack stress and warpage is a major concern which causes handling and alignment problems during processing. The bonding material and carrier will need to be specifically suited to minimize the effects of stress in the compound wafer. Such material must balance rigidity with warp to prevent lateral die shift and deformation induced by coefficient of thermal expansion (CTE) mismatch between the carrier and EMC material [2]. Bonding materials must also have enough adhesion to the EMC material to overcome such stress without bond failure for an associated debond path (such as laser or mechanical release). In this experiment, we will examine a thermoplastic bonding material in combination with different release materials, addressing die shift, and deformation after EMC processing. Successful pairs will then undergo carrier release using either mechanical release or laser ablation release technology.