Analysis, Simulation, And Development Of A Low-Cost Fully Active-Electrode Bioimpedance Measurement Module

A low-cost 1 kHz-400 kHz operating frequency fully-active electrode bioimpedance measurement module, based on Howland current source, is presented in this paper. It includes a buffered positive feedback Howland current source, implemented with operational amplifiers, as well as an AD8421 instrumentation amplifier, for the differential voltage measurements. Each active electrode module can be connected to others, assembling a wearable active electrode module array. From this array, 2 electrodes can be selected to be driven from a THS413 fully differential amplifier, activating a mirrored Howland current source. This work performs a complete circuit analysis, verified with MATLAB and SPICE simulations of the current source's transconductance and output impedance over the frequency range between 1 kHz and 1 MHz. Resistors' tolerances, possible mismatches, and the operational amplifiers' non-idealities are considered in both the analysis and simulations. A comparison study between four selected operational amplifiers (ADA4622, OPA2210, AD8034, and AD8672) is additionally performed. The module is also hardware-implemented and tested in the lab for all four operational amplifiers and the transconductance is measured for load resistors of 150 Omega, 660 Omega, and 1200 Omega. Measurements showed that, using the AD8034 operational amplifier, the current source's transconductance remains constant for frequencies up to 400 KHz for a 150 Omega load and 250 kHz for a 1200 Omega load, while lower performance is achieved with the other 3 operational amplifiers. Finally, transient simulations and measurements are performed at the AD8421 output for bipolar measurements on the 3 aforementioned load resistor values.